Mon-Fri 8am-5pm PST Live Customer Service & Technical Support
888-800-9629
(0) $0.00 (US)
|
BoschSparkPlugs.net is part of the SparkPlugs.com family - an authorized Bosch distributor. To contact Bosch USA, click here.
Learning Center
Share |

OE Identical Oxygen Sensors Installation Instructions

READ ALL INSTRUCTIONS PRIOR TO INSTALLATION

Handling
*DO NOT drop or use an oxygen sensor that has been dropped as this may have caused shock damage to the ceramic cell
*DO NOT use any compounds on or around the sensor unless labeled as oxygen sensor friendly products
*DO NOT use impact wrench or conventional socket type wrench to install sensor
*DO NOT allow sensor or lead wire to touch exhaust manifold or any other hot component
*DO NOT expose this product to water, oil, windshield cleaner, anti-corrosion oil, grease, terminal cleaner, etc.
*DO NOT use leaded fuels, silicone or metal based additives
*DO NOT store under high humidity conditions

Installation
1. Disconnect the battery.

2. Disconnect wiring harness from old sensor. Remove any hardware or clips, if applicable. Use an oxygen sensor socket to remove the old sensor.

3. Remove protector cap on new sensor just prior to installation.

4. If not already coated, apply (enclosed) anti-seize to oxygen sensor threads.

5. Use oxygen sensor socket to install sensor body, ensuring lead wire is not twisted or bent.

  • Flanged applications - (where flange is NOT already installed on sensor) Install flange to exhaust manifold first, then mount sensor in flange. (A copper gasket is bonded to the flange & no additional gasket is required)
  • Flanged applications - (where flange is already installed on sensor)  It is important to use the supplied gasket before installing sensor. 

 6. Torque to proper specs as below:

  • M18 sensors (sensors with 18mm diameter threads) - Install finger tight then 1/2-3/4 turn with wrench / O2 sensor socket 26-33ft. lbs.
  • M12 sensors (sensors with 18mm diameter threads) - Install finger tight then 3/4 - 1 turn with wrench / O2 sensor socket 13.2 -17ft. lbs.

7. Put in place any hardware or clips, if applicable.

8. Connect and route lead wire as originally installed.

9. Reconnect the battery.


Warning: Anti-seize compound may cause irritation to the skin or eyes. In case of contact, wash affected area with soap and water. In case of eye contact, flush with water for 15 minutes. If irritation persists, consult a physician. If swallowed, DO NOT induce vomiting. 

questions?
call us (888-800-9629)
LOOKING FOR WHOLESALE PRICING? Contact Us for Quotes
SPARKPLUGS.COM
PO Box 772
Sun City, CA 92586
CUSTOMER SERVICE
Toll Free: 888-800-9629
Out of U.S call 951-672-8501